Re: DVD and CD Burner issues....

On 10/29/10 23:33, Dave Sampson wrote:
> No errors,
>
> When I pop a Cd in the first CD/DVD rom it is not recognized and doesn't
> mount. Consequently the same happens when I put a DVD in the second
> CD/DVD Rom.
>
> They both used to burn both media fine, but now each one is picky which
> one its will accept.
>
> I have had a few issues with MD5SUMS actually clearing too. Maybe they
> both have tired lasers and I should just replace them both.
>
> I tried to find out how to clear the info out of the system config.
> Short of re-installing I found no solutions.
>
> running dmesg shows both devices recognized as they should be. All
> modules loaded appropriately as well.
>
> Looks like it is time for tigerdirect.ca.
>
> Cheers
>
> On Wed, 2010-10-13 at 00:45 -0400, Mike wrote:
>> On Tuesday 12 October 2010 19:49:53 Dave Sampson wrote:
>>> Hey Folks,
>>>
>>> Just curious if anyone has ever had a cd/dvd burner that recognized
>>> blank DVD's but not blank CD's.
>>>
>>> Any thoughts?
>>>
>>> Running Ubuntu 9.04..
>>>
>>> Current solution is to run two burners, one of CD's and one for dvd's.
>>>
>>> Is there a way to make the system reconfigure one of the drives to give
>>> default behaviour?
>> Did you get an error message about TAO,  I had that the other day when I tried 
>> to burn a CD with my DVD Burner.  I was using Kubuntu9.04 at the time,  also 
>> tried with UNR.
Try to mount it manually and post the output from dmesg.
-- 
OCLUG general discussion list
[email protected]
http://oclug.on.ca/mailman/listinfo/oclug