Re: [PHP-GTK] php-gtk w/ scintilla

Yes, buildconf calls cvsclean. You don't always have to run cvsclean.

-Andrei

Pablo Dall'Oglio wrote:
> When you say runs ON buildconf you meant buildconf calls cvsclean ?
> I thought we should always run cvsclean before make the cvs version.
> 
> Pablo
> 
> 
> Em Ter, 2007-10-23 às 09:09 -0700, Andrei Zmievski escreveu:
>> cvsclean runs only on buildconf. Is that a problem?
>>
>> -Andrei
>>
>> Pablo Dall'Oglio wrote:
>>> Hi Andrei,
>>>
>>> Tested, works fine.
>>>
>>> Just a problem I faced while compiling with --enable-scintilla.
>>> it complaints there's no more gen_scintilla.c and gen_scintilla.h
>>>
>>> I found out that ./cvsclean is removing these files. See:
>>>
>>> # ls ext/scintilla/
>>> =======================
>>> config.m4 CVS gen_scintilla.h  libscintilla php_scintilla.c 
>>> sci_generator.php config.w32  gen_scintilla.c  gtkscintilla.h  
>>> Makefile.frag  php_scintilla.h  scintilla.in
>>>
>>> # ./cvsclean
>>>
>>> # ls ext/scintilla/
>>> =======================
>>> config.m4   CVS libscintilla   php_scintilla.c  sci_generator.php
>>> config.w32  gtkscintilla.h  Makefile.frag  php_scintilla.h  scintilla.in
>>>
>>> Another thing that is not working. I know it's not related to you, but
>>> possibilly to Anant is that scintilla is not doing sintax highlight
>>> under linux, just under windows with those binaries from mary.
>>>
>>> bests
>>> Pablo
>>>
>>>
>>> Em Seg, 2007-10-22 às 22:35 -0700, Andrei Zmievski escreveu:
>>>> Committed an untested fix. You'll need to force buildconf to rebuild  
>>>> configure.
>>>>
>>>> -Andrei
>>>> http://10fathoms.org/vu - daily photoblog
>>>>
>>>> On Oct 22, 2007, at 5:24 PM, Fernando Correa da Conceição wrote:
>>>>
>>>>> pablo dalloglio escreveu:
>>>>>> Hello,
>>>>>>
>>>>>> When compiling either php-gtk-2.0.0beta or cvs version **WITH**
>>>>>> --enable-scintila gives me the error below. Removing scintilla,
>>>>>> everything is ok.
>>>>>>
>>>>>> PHP-GTK2 alpha compiled with gtkscintilla (separated, not embed)  
>>>>>> used to
>>>>>> work...
>>>>>>
>>>>>> anybody ?
>>>>>>
>>>>>>
>>>>>> php-gtk2 -v
>>>>>> PHP Warning:  PHP Startup: Unable to load dynamic library
>>>>>> '/usr/local/php-gtk2/lib/php/extensions/no-debug-non-zts-20060613/ 
>>>>>> php_gtk2.so' - /usr/local/php-gtk2/lib/php/extensions/no-debug-non- 
>>>>>> zts-20060613/php_gtk2.so: undefined symbol:  
>>>>>> _ZTVN10__cxxabiv117__class_type_infoE in Unknown on line 0
>>>>>> PHP 5.2.4 (cli) (built: Oct 22 2007 19:26:48) Copyright (c)  
>>>>>> 1997-2007 The PHP Group
>>>>>> Zend Engine v2.2.0, Copyright (c) 1998-2007 Zend Technologies
>>>>>>
>>>>>>
>>>>> I reported this some time. The message and the fix(note: this is a  
>>>>> copy and past from a previous message):
>>>>>
>>>>> GtkScintilla do not work for me(again...) on linux, using debian  
>>>>> etch(kurumin). There is an undefined reference to a cxx funcion.  
>>>>> This time I have a simple fix, on the line PHP_GTK2_SHARED_LIBADD  
>>>>> in the makefile, add as the last item -lstdc++ . Works for me.
>>>>>
>>>>> Change this AFTER the ./configure --enable-scintilla
>>>>> If you enable mozenbed it will wok, because it add -lstdc++
>>>>>
>>>>> But i do not know the best way to fix this on the makefiles
>>>>>
>>>>> Fernando Correa da Conceição
>>>>>
>>>>> -- 
>>>>> PHP-GTK General Mailing List (http://gtk.php.net/)
>>>>> To unsubscribe, visit: http://www.php.net/unsub.php
>