Re: [PHP-GTK] php-gtk w/ scintilla

humm, so it's not a problem :-)
I just have to remove ./cvsclean from my head.

thanks!
Pablo


Em Ter, 2007-10-23 às 09:17 -0700, Andrei Zmievski escreveu:
> Yes, buildconf calls cvsclean. You don't always have to run cvsclean.
> 
> -Andrei
> 
> Pablo Dall'Oglio wrote:
> > When you say runs ON buildconf you meant buildconf calls cvsclean ?
> > I thought we should always run cvsclean before make the cvs version.
> > 
> > Pablo
> > 
> > 
> > Em Ter, 2007-10-23 às 09:09 -0700, Andrei Zmievski escreveu:
> >> cvsclean runs only on buildconf. Is that a problem?
> >>
> >> -Andrei
> >>
> >> Pablo Dall'Oglio wrote:
> >>> Hi Andrei,
> >>>
> >>> Tested, works fine.
> >>>
> >>> Just a problem I faced while compiling with --enable-scintilla.
> >>> it complaints there's no more gen_scintilla.c and gen_scintilla.h
> >>>
> >>> I found out that ./cvsclean is removing these files. See:
> >>>
> >>> # ls ext/scintilla/
> >>> =======================
> >>> config.m4 CVS gen_scintilla.h  libscintilla php_scintilla.c 
> >>> sci_generator.php config.w32  gen_scintilla.c  gtkscintilla.h  
> >>> Makefile.frag  php_scintilla.h  scintilla.in
> >>>
> >>> # ./cvsclean
> >>>
> >>> # ls ext/scintilla/
> >>> =======================
> >>> config.m4   CVS libscintilla   php_scintilla.c  sci_generator.php
> >>> config.w32  gtkscintilla.h  Makefile.frag  php_scintilla.h  scintilla.in
> >>>
> >>> Another thing that is not working. I know it's not related to you, but
> >>> possibilly to Anant is that scintilla is not doing sintax highlight
> >>> under linux, just under windows with those binaries from mary.
> >>>
> >>> bests
> >>> Pablo
> >>>
> >>>
> >>> Em Seg, 2007-10-22 às 22:35 -0700, Andrei Zmievski escreveu:
> >>>> Committed an untested fix. You'll need to force buildconf to rebuild  
> >>>> configure.
> >>>>
> >>>> -Andrei
> >>>> http://10fathoms.org/vu - daily photoblog
> >>>>
> >>>> On Oct 22, 2007, at 5:24 PM, Fernando Correa da Conceição wrote:
> >>>>
> >>>>> pablo dalloglio escreveu:
> >>>>>> Hello,
> >>>>>>
> >>>>>> When compiling either php-gtk-2.0.0beta or cvs version **WITH**
> >>>>>> --enable-scintila gives me the error below. Removing scintilla,
> >>>>>> everything is ok.
> >>>>>>
> >>>>>> PHP-GTK2 alpha compiled with gtkscintilla (separated, not embed)  
> >>>>>> used to
> >>>>>> work...
> >>>>>>
> >>>>>> anybody ?
> >>>>>>
> >>>>>>
> >>>>>> php-gtk2 -v
> >>>>>> PHP Warning:  PHP Startup: Unable to load dynamic library
> >>>>>> '/usr/local/php-gtk2/lib/php/extensions/no-debug-non-zts-20060613/ 
> >>>>>> php_gtk2.so' - /usr/local/php-gtk2/lib/php/extensions/no-debug-non- 
> >>>>>> zts-20060613/php_gtk2.so: undefined symbol:  
> >>>>>> _ZTVN10__cxxabiv117__class_type_infoE in Unknown on line 0
> >>>>>> PHP 5.2.4 (cli) (built: Oct 22 2007 19:26:48) Copyright (c)  
> >>>>>> 1997-2007 The PHP Group
> >>>>>> Zend Engine v2.2.0, Copyright (c) 1998-2007 Zend Technologies
> >>>>>>
> >>>>>>
> >>>>> I reported this some time. The message and the fix(note: this is a  
> >>>>> copy and past from a previous message):
> >>>>>
> >>>>> GtkScintilla do not work for me(again...) on linux, using debian  
> >>>>> etch(kurumin). There is an undefined reference to a cxx funcion.  
> >>>>> This time I have a simple fix, on the line PHP_GTK2_SHARED_LIBADD  
> >>>>> in the makefile, add as the last item -lstdc++ . Works for me.
> >>>>>
> >>>>> Change this AFTER the ./configure --enable-scintilla
> >>>>> If you enable mozenbed it will wok, because it add -lstdc++
> >>>>>
> >>>>> But i do not know the best way to fix this on the makefiles
> >>>>>
> >>>>> Fernando Correa da Conceição
> >>>>>
> >>>>> -- 
> >>>>> PHP-GTK General Mailing List (http://gtk.php.net/)
> >>>>> To unsubscribe, visit: http://www.php.net/unsub.php
> > 
-- 
um abraço!
Pablo Dall'Oglio