Re: [PHP-INSTALL] Problem install php 4.3.10 and oracle 10g and RH3AS

I have both, if i use only --with-oci8=$ORACLE_HOME, it will compile without
problems (I already tested and works)

if i use  --with-oracle=$ORACLE_HOME and --with-oci8=$ORACLE_HOME, i  got
the error

checking for Oracle-ORACLE support... yes
checking Oracle Install-Dir... /opt/oracle/product/base10g
checking Oracle version... configure: error: Oracle needed libraries not
found

I read that i have to put manually the version 10 of oracle in the configure
file, but i do not know how or where



----- Original Message ----- 
From: "Chris Hewitt" <[email protected]>
Newsgroups: php.install
To: "Fabricio Vargas" <[email protected]>
Cc: "PHP Install List" <[email protected]>
Sent: Friday, December 31, 2004 10:09 AM
Subject: Re: [PHP-INSTALL] Problem install php 4.3.10 and oracle 10g and
RH3AS


> On Thu, 2004-12-30 at 14:14, Fabricio Vargas wrote:
> > Hi
> > I am new using php. I am trying to install php 4.3.10 with oracle
> > 10.1. The operating system is Red Hat 3AS
> >
> > I did this command
> >
> >  ./configure --with-apxs2=/usr/sbin/apxs --prefix=$ORACLE_HOME
> > --enable-track-vars --with-oci8=$ORACLE_HOME  --with-gd
> > --enable-sigchild --with-zlib --disable-rpath
> > --with-config-file-path=/etc/httpd/conf --with-oracle=$ORACLE_HOME
>
> Fabricio,
>
> I've not had time to check in the manual but do you need both
> --with-oracle and --with-oci8? From memory, --with-oracle is aimed at
> Oracle 7.
>
> HTH
>
> Chris