Re: [PHP-INSTALL] Problem install php 4.3.10 and oracle 10g and RH3AS

the problem was solved here

http://www.webmasterworld.com/forum88/5604.htm

thanks to everybody



----- Original Message ----- 
From: "Fabricio Vargas" <[email protected]>
To: "Chris Hewitt" <[email protected]>
Cc: <[email protected]>
Sent: Monday, January 03, 2005 2:38 PM
Subject: Re: [PHP-INSTALL] Problem install php 4.3.10 and oracle 10g and
RH3AS


> I have both, if i use only --with-oci8=$ORACLE_HOME, it will compile
without
> problems (I already tested and works)
>
> if i use  --with-oracle=$ORACLE_HOME and --with-oci8=$ORACLE_HOME, i  got
> the error
>
> checking for Oracle-ORACLE support... yes
> checking Oracle Install-Dir... /opt/oracle/product/base10g
> checking Oracle version... configure: error: Oracle needed libraries not
> found
>
> I read that i have to put manually the version 10 of oracle in the
configure
> file, but i do not know how or where
>
>
>
> ----- Original Message ----- 
> From: "Chris Hewitt" <[email protected]>
> Newsgroups: php.install
> To: "Fabricio Vargas" <[email protected]>
> Cc: "PHP Install List" <[email protected]>
> Sent: Friday, December 31, 2004 10:09 AM
> Subject: Re: [PHP-INSTALL] Problem install php 4.3.10 and oracle 10g and
> RH3AS
>
>
> > On Thu, 2004-12-30 at 14:14, Fabricio Vargas wrote:
> > > Hi
> > > I am new using php. I am trying to install php 4.3.10 with oracle
> > > 10.1. The operating system is Red Hat 3AS
> > >
> > > I did this command
> > >
> > >  ./configure --with-apxs2=/usr/sbin/apxs --prefix=$ORACLE_HOME
> > > --enable-track-vars --with-oci8=$ORACLE_HOME  --with-gd
> > > --enable-sigchild --with-zlib --disable-rpath
> > > --with-config-file-path=/etc/httpd/conf --with-oracle=$ORACLE_HOME
> >
> > Fabricio,
> >
> > I've not had time to check in the manual but do you need both
> > --with-oracle and --with-oci8? From memory, --with-oracle is aimed at
> > Oracle 7.
> >
> > HTH
> >
> > Chris
>