Re: [xeneis rc5] SATA Controller erkennt Platte nicht

On Tue, 08 Feb 2011 22:52:17 +0100, Stefan Kuhne <[email protected]>
wrote:

>Am 08.02.2011 22:12, schrieb Peter Schauder:
>
>Hallo,

>muff:
>"dmesg | grep -A 10 sata_via"

txen # dmesg | grep -A 10 sata_via
[    4.992366] sata_via 0000:00:09.0: version 2.3
[    4.992418] ACPI: PCI Interrupt 0000:00:09.0[A] -> GSI 16 (level,
low) -> IRQ 16
[    4.992527] sata_via 0000:00:09.0: routed to hard irq line 11
[    4.992805] scsi0 : sata_via
[    4.994621] scsi1 : sata_via
[    4.996498] scsi2 : sata_via
[    4.996604] ata1: SATA max UDMA/133 port i16@0x6400 bmdma 0x7400
irq 16
[    4.996611] ata2: SATA max UDMA/133 port i16@0x6800 bmdma 0x7408
irq 16
[    4.996615] ata3: PATA max UDMA/133 port i16@0x6c00 bmdma 0x7410
irq 16
[    5.305737] ata1: SATA link down (SStatus 0 SControl 310)
[    5.629732] ata2: SATA link down (SStatus 0 SControl 310)
[    5.811075] ACPI: PCI Interrupt Link [LNKD] enabled at IRQ 11
[    5.811096] ACPI: PCI Interrupt 0000:00:11.2[D] -> Link [LNKD] ->
GSI 11 (level, low) -> IRQ 11
[    5.811106] PCI: VIA VLink IRQ fixup for 0000:00:11.2, from 12 to
11
[    5.811141] uhci_hcd 0000:00:11.2: UHCI Host Controller
[    5.811308] uhci_hcd 0000:00:11.2: new USB bus registered, assigned
bus number 1
txen #        
>
>Oder "dmesg | grep -A 10 $HDD" HDD = Festplattenhersteller
>(wahrscheinlich nur Grossbuchstaben)
txen # dmesg | grep -A 10 SAMSUNG
[    3.261863] hda: SAMSUNG SV6003H, ATA DISK drive
[    3.261949] hda: host max PIO5 wanted PIO255(auto-tune) selected
PIO4
[    3.262089] hda: UDMA/100 mode selected
[    3.262299] ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
[    3.269006] Probing IDE interface ide1...
[    4.185866] hdd: LITE-ON LTR-32123S, ATAPI CD/DVD-ROM drive
[    4.969847] hdc: HL-DT-STDVD-ROM GDR8160B, ATAPI CD/DVD-ROM drive
[    4.969869] hdc: host max PIO5 wanted PIO255(auto-tune) selected
PIO4
[    4.970524] hdc: drive side 80-wire cable detection failed,
limiting max speed to UDMA33
[    4.970528] hdc: UDMA/33 mode selected
[    4.983477] hdd: host max PIO5 wanted PIO255(auto-tune) selected
PIO4
txen #                                           
Aber Achtung: da ist auch eine IDE Samsung verbaut (60 GB).

>
>Stefan Kuhne