Re: [PULL linux-firmware] ath10k, ath11k and ath12k firmware ath-20260130
Dmitry Baryshkov <[email protected]>
| Newsgroups | org.infradead.lists.ath11k,org.infradead.lists.ath10k,org.infradead.lists.ath12k,org.kernel.lore.linux-firmware,org.kernel.vger.linux-wireless |
|---|---|
| Message-ID | <34lnv35rbicqk6duyqhhidunulcipttsj6ryvzw6embgablnpl@gh3wtsknmcma> |
On Fri, Jan 30, 2026 at 12:29:48PM -0800, Jeff Johnson wrote: > Hi, > Here's a new pull request for ath10k, ath11k and ath12k. > > For ath12k: > > Update firmware for QCN9274/hw2.0. > > Update board file for WCN7850/hw2.0 to support: > bus=pci,vendor=17cb,device=1107,subsystem-vendor=1eac,subsystem-device=8001,qmi-chip-id=2,qmi-board-id=255 > bus=pci,vendor=17cb,device=1107,subsystem-vendor=1eac,subsystem-device=8004,qmi-chip-id=2,qmi-board-id=255 These two were not a part of the previous upload, but... They again have board-id of 255 (unprogrammed). Why is there no calibration variant? > > > Please let me know if there are any problems. -- With best wishes Dmitry