Re: [PULL linux-firmware] ath10k, ath11k and ath12k firmware ath-20260130

On Sat, Jan 31, 2026 at 08:39:57AM +0200, Dmitry Baryshkov wrote:
> On Fri, Jan 30, 2026 at 12:29:48PM -0800, Jeff Johnson wrote:
> > Hi,
> > Here's a new pull request for ath10k, ath11k and ath12k.
> > 
> > For ath12k:
> > 
> > Update firmware for QCN9274/hw2.0.
> > 
> > Update board file for WCN7850/hw2.0 to support:
> > bus=pci,vendor=17cb,device=1107,subsystem-vendor=1eac,subsystem-device=8001,qmi-chip-id=2,qmi-board-id=255
> > bus=pci,vendor=17cb,device=1107,subsystem-vendor=1eac,subsystem-device=8004,qmi-chip-id=2,qmi-board-id=255
> 
> These two were not a part of the previous upload, but... They again have
> board-id of 255 (unprogrammed). Why is there no calibration variant?

Our engineers clarified that for the PCIe cards with the programmed
subsystem-vendor and device we don't need calibration variant even if
board-id is 255.

Merged and pushed out: https://gitlab.com/kernel-firmware/linux-firmware/-/merge_requests/899

> 
> > 
> > 
> > Please let me know if there are any problems.
> 
> -- 
> With best wishes
> Dmitry

-- 
With best wishes
Dmitry