Re: [PATCH] ASoC: meson: aiu: fifo-spdif: soft reset the S/PDIF datapath on start/stop

> On 26 Jun 2026, at 12:04 pm, Christian Hewitt <[email protected]> wrote:
> 
> The I2S FIFO soft-resets its fast domain on start (AIU_RST_SOFT bit 0 +
> AIU_I2S_SYNC read in aiu_fifo_i2s_trigger), mirroring the downstream
> vendor driver's audio_out_i2s_enable(). The S/PDIF FIFO has no equivalent:
> it only toggles the IEC958 DCU, so a stale datapath FIFO can be replayed,
> producing the "machine gun noise" buffer underrun - on start when switching
> outputs, and on stop when playback ends. The latter is audible on devices
> with an always-on S/PDIF-fed DAC (e.g. the ES7144 on the WeTek Play2).
> 
> The vendor driver resets the IEC958 fast domain (AIU_RST_SOFT bit 2) on
> both enable and disable (audio_hw_958_enable), and when reconfiguring
> (audio_hw_958_reset clears AIU_958_DCU_FF_CTRL then resets). Do the same:
> reset before enabling the DCU on start, and after disabling it on stop.

Fixes: 6ae9ca9ce986bf ("ASoC: meson: aiu: add i2s and spdif support”)

^ I can send a v2 with it done properly if needed?

> Signed-off-by: Christian Hewitt <[email protected]>
> ---
> sound/soc/meson/aiu-fifo-spdif.c | 5 +++++
> 1 file changed, 5 insertions(+)
> 
> diff --git a/sound/soc/meson/aiu-fifo-spdif.c b/sound/soc/meson/aiu-fifo-spdif.c
> index e0e00ec026dc..826055a71421 100644
> --- a/sound/soc/meson/aiu-fifo-spdif.c
> +++ b/sound/soc/meson/aiu-fifo-spdif.c
> @@ -24,6 +24,7 @@
> #define AIU_MEM_IEC958_CONTROL_MODE_16BIT BIT(7)
> #define AIU_MEM_IEC958_CONTROL_MODE_LINEAR BIT(8)
> #define AIU_MEM_IEC958_BUF_CNTL_INIT BIT(0)
> +#define AIU_RST_SOFT_958_FAST BIT(2)
> 
> #define AIU_FIFO_SPDIF_BLOCK 8
> 
> @@ -68,12 +69,16 @@ static int fifo_spdif_trigger(struct snd_pcm_substream *substream, int cmd,
> case SNDRV_PCM_TRIGGER_START:
> case SNDRV_PCM_TRIGGER_RESUME:
> case SNDRV_PCM_TRIGGER_PAUSE_RELEASE:
> + snd_soc_component_write(component, AIU_RST_SOFT,
> + AIU_RST_SOFT_958_FAST);
> fifo_spdif_dcu_enable(component, true);
> break;
> case SNDRV_PCM_TRIGGER_SUSPEND:
> case SNDRV_PCM_TRIGGER_PAUSE_PUSH:
> case SNDRV_PCM_TRIGGER_STOP:
> fifo_spdif_dcu_enable(component, false);
> + snd_soc_component_write(component, AIU_RST_SOFT,
> + AIU_RST_SOFT_958_FAST);
> break;
> default:
> return -EINVAL;
> -- 
> 2.43.0

_______________________________________________
linux-amlogic mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/linux-amlogic