Re: [PATCH v2 3/4] arm64: dts: rockchip: Add crypto node to rk356x-base

On Fri Jul 10, 2026 at 4:30 PM CEST, Dawid Olesinski wrote:
> On Thu, 09 Jul 2026 09:07:23 +0200
> Heiko Stübner <[email protected]> wrote:
>
>> Am Donnerstag, 9. Juli 2026, 01:56:10 Mitteleuropäische Sommerzeit
>> schrieb Sebastian Reichel:
>> > Hi,
>> > 
>> > On Wed, Jul 08, 2026 at 06:58:24PM +0100, Dawid Olesinski wrote:  
>> > > Add the device tree node for the V2 cryptographic hardware
>> > > accelerator on RK356x SoCs (RK3566, RK3568).
>> > > 
>> > > The IP block sits in the non-secure peripheral domain. Its three
>> > > clocks (core, aclk, hclk) and reset line are accessible directly
>> > > through the main non-secure CRU, so no firmware intermediary is
>> > > required.
>> > > 
>> > > The node is disabled by default; board files that wish to use
>> > > hardware crypto offload must enable it.  
>> > 
>> > Why is it disabled by default? It doesn't seem to be board specific
>> > at all to me (the same question applies to the RK3588 DT).  
>> 
>> You're definitly right about that ... there are no board specific
>> resources needed, so Dawid please drop the status from both nodes.
>> 
>
> I'll drop the `status = "disabled";` 
> lines from both the RK356x and RK3588 device trees in v3.

That also means you can drop the label/phandle as there's no longer a need
to reference it in board files.

Cheers,
  Diederik

> Thanks for the review!
>
> Dawid
>
>> > > 
>> > > Signed-off-by: Dawid Olesinski <[email protected]>
>> > > ---
>> > >  arch/arm64/boot/dts/rockchip/rk356x-base.dtsi | 12 ++++++++++++
>> > >  1 file changed, 12 insertions(+)
>> > > 
>> > > diff --git a/arch/arm64/boot/dts/rockchip/rk356x-base.dtsi
>> > > b/arch/arm64/boot/dts/rockchip/rk356x-base.dtsi index
>> > > a5832895bd39..9de7e7487ca1 100644 ---
>> > > a/arch/arm64/boot/dts/rockchip/rk356x-base.dtsi +++
>> > > b/arch/arm64/boot/dts/rockchip/rk356x-base.dtsi @@ -1112,6
>> > > +1112,18 @@ sdhci: mmc@fe310000 { status = "disabled";
>> > >  	};
>> > >  
>> > > +	crypto: crypto@fe380000 {
>> > > +		compatible = "rockchip,rk3568-crypto";
>> > > +		reg = <0x0 0xfe380000 0x0 0x2000>;
>> > > +		interrupts = <GIC_SPI 4 IRQ_TYPE_LEVEL_HIGH>;
>> > > +		clocks = <&cru CLK_CRYPTO_NS_CORE>, <&cru
>> > > ACLK_CRYPTO_NS>,
>> > > +			 <&cru HCLK_CRYPTO_NS>;
>> > > +		clock-names = "core", "aclk", "hclk";
>> > > +		resets = <&cru SRST_CRYPTO_NS_CORE>;
>> > > +		reset-names = "core";
>> > > +		status = "disabled";
>> > > +	};
>> > > +
>> > >  	/*
>> > >  	 * Testing showed that the HWRNG found in RK3566
>> > > produces unacceptably
>> > >  	 * low quality of random data, so the HWRNG isn't
>> > > enabled for all RK356x  
>> >   
>> 
>> 
>> 
>> 
>
>
> _______________________________________________
> Linux-rockchip mailing list
> [email protected]
> http://lists.infradead.org/mailman/listinfo/linux-rockchip


_______________________________________________
Linux-rockchip mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/linux-rockchip