Re: [PULL linux-firmware] ath10k, ath11k and ath12k firmware ath-20260130

Dmitry Baryshkov <[email protected]> Sat, 31 Jan 2026 08:39:57 +0200

Newsgroups	org.kernel.lore.linux-firmware,org.infradead.lists.ath10k,org.infradead.lists.ath11k,org.infradead.lists.ath12k,org.kernel.vger.linux-wireless
Message-ID	<34lnv35rbicqk6duyqhhidunulcipttsj6ryvzw6embgablnpl@gh3wtsknmcma>

On Fri, Jan 30, 2026 at 12:29:48PM -0800, Jeff Johnson wrote:
> Hi,
> Here's a new pull request for ath10k, ath11k and ath12k.
> 
> For ath12k:
> 
> Update firmware for QCN9274/hw2.0.
> 
> Update board file for WCN7850/hw2.0 to support:
> bus=pci,vendor=17cb,device=1107,subsystem-vendor=1eac,subsystem-device=8001,qmi-chip-id=2,qmi-board-id=255
> bus=pci,vendor=17cb,device=1107,subsystem-vendor=1eac,subsystem-device=8004,qmi-chip-id=2,qmi-board-id=255

These two were not a part of the previous upload, but... They again have
board-id of 255 (unprogrammed). Why is there no calibration variant?

> 
> 
> Please let me know if there are any problems.

-- 
With best wishes
Dmitry