Re: [PULL linux-firmware] ath10k, ath11k and ath12k firmware ath-20260130
Dmitry Baryshkov <[email protected]> Mon, 2 Feb 2026 11:11:24 +0200
| Newsgroups | org.kernel.lore.linux-firmware,org.infradead.lists.ath10k,org.infradead.lists.ath11k,org.infradead.lists.ath12k,org.kernel.vger.linux-wireless |
|---|---|
| Message-ID | <cwzz5ndtvkr3dqn5xr4erfdhi2pb7xjijcu3c23pdpfgnmlyvd@nuvbtkakxile> |
On Sat, Jan 31, 2026 at 08:39:57AM +0200, Dmitry Baryshkov wrote: > On Fri, Jan 30, 2026 at 12:29:48PM -0800, Jeff Johnson wrote: > > Hi, > > Here's a new pull request for ath10k, ath11k and ath12k. > > > > For ath12k: > > > > Update firmware for QCN9274/hw2.0. > > > > Update board file for WCN7850/hw2.0 to support: > > bus=pci,vendor=17cb,device=1107,subsystem-vendor=1eac,subsystem-device=8001,qmi-chip-id=2,qmi-board-id=255 > > bus=pci,vendor=17cb,device=1107,subsystem-vendor=1eac,subsystem-device=8004,qmi-chip-id=2,qmi-board-id=255 > > These two were not a part of the previous upload, but... They again have > board-id of 255 (unprogrammed). Why is there no calibration variant? Our engineers clarified that for the PCIe cards with the programmed subsystem-vendor and device we don't need calibration variant even if board-id is 255. Merged and pushed out: https://gitlab.com/kernel-firmware/linux-firmware/-/merge_requests/899 > > > > > > > Please let me know if there are any problems. > > -- > With best wishes > Dmitry -- With best wishes Dmitry