[PATCH v3 5/6] arm64: ambarella: add ARCH_AMBARELLA and CV75 EVK DT
Long Zhao via B4 Relay <[email protected]>
| Newsgroups | org.kernel.vger.linux-clk,dev.linux.lists.soc,org.infradead.lists.linux-arm-kernel,org.kernel.feeds.b4-sent,org.kernel.vger.linux-devicetree,org.kernel.vger.linux-kernel |
|---|---|
| Message-ID | <[email protected]> |
From: Long Zhao <[email protected]> Enable ARCH_AMBARELLA and add a minimal CV75 SoC / EVK device tree for console bring-up with the RCT clocks, UART, pinctrl and GPIO banks. Signed-off-by: Long Zhao <[email protected]> --- arch/arm64/Kconfig.platforms | 9 ++ arch/arm64/boot/dts/Makefile | 1 + arch/arm64/boot/dts/ambarella/Makefile | 3 + arch/arm64/boot/dts/ambarella/cv75-evk.dts | 30 +++++ arch/arm64/boot/dts/ambarella/cv75.dtsi | 178 +++++++++++++++++++++++++++++ arch/arm64/configs/defconfig | 1 + 6 files changed, 222 insertions(+) diff --git a/arch/arm64/Kconfig.platforms b/arch/arm64/Kconfig.platforms index d2acfac73003..166430ddb3c9 100644 --- a/arch/arm64/Kconfig.platforms +++ b/arch/arm64/Kconfig.platforms @@ -26,6 +26,15 @@ config ARCH_SUNXI help This enables support for Allwinner sunxi based SoCs like the A64. +config ARCH_AMBARELLA + bool "Ambarella SoC family" + select ARM_PSCI + select HAVE_ARM_ARCH_TIMER + select PINCTRL + select PINCTRL_AMB + help + This enables support for the ARM64 based Ambarella SoCs like CV75. + config ARCH_ALPINE bool "Annapurna Labs Alpine platform" select ALPINE_MSI if PCI diff --git a/arch/arm64/boot/dts/Makefile b/arch/arm64/boot/dts/Makefile index fc726b215f12..f1709eb5d915 100644 --- a/arch/arm64/boot/dts/Makefile +++ b/arch/arm64/boot/dts/Makefile @@ -4,6 +4,7 @@ subdir-y += airoha subdir-y += allwinner subdir-y += altera subdir-y += amazon +subdir-y += ambarella subdir-y += amd subdir-y += amlogic subdir-y += apm diff --git a/arch/arm64/boot/dts/ambarella/Makefile b/arch/arm64/boot/dts/ambarella/Makefile new file mode 100644 index 000000000000..ddca3d7b18cc --- /dev/null +++ b/arch/arm64/boot/dts/ambarella/Makefile @@ -0,0 +1,3 @@ +# SPDX-License-Identifier: GPL-2.0 + +dtb-$(CONFIG_ARCH_AMBARELLA) += cv75-evk.dtb diff --git a/arch/arm64/boot/dts/ambarella/cv75-evk.dts b/arch/arm64/boot/dts/ambarella/cv75-evk.dts new file mode 100644 index 000000000000..42a0fe24b83b --- /dev/null +++ b/arch/arm64/boot/dts/ambarella/cv75-evk.dts @@ -0,0 +1,30 @@ +// SPDX-License-Identifier: GPL-2.0-or-later +/* + * Ambarella CV75 EVK board + */ + +/dts-v1/; + +#include "cv75.dtsi" + +/ { + model = "Ambarella CV75 EVK Board"; + compatible = "ambarella,cv75-evk", "ambarella,cv75"; + + aliases { + serial0 = &uart0; + }; + + chosen { + stdout-path = &uart0; + }; + + memory@200000 { + device_type = "memory"; + reg = <0x0 0x00200000 0x0 0x07e00000>; + }; +}; + +&uart0 { + status = "okay"; +}; diff --git a/arch/arm64/boot/dts/ambarella/cv75.dtsi b/arch/arm64/boot/dts/ambarella/cv75.dtsi new file mode 100644 index 000000000000..994eac6728ce --- /dev/null +++ b/arch/arm64/boot/dts/ambarella/cv75.dtsi @@ -0,0 +1,178 @@ +// SPDX-License-Identifier: GPL-2.0-or-later +/* + * Ambarella CV75 SoC + * + * Boot peripheral: UART0 console. + * Clocks: a single ambarella,cv75-rct provider. + */ + +#include <dt-bindings/clock/ambarella,cv75-rct.h> +#include <dt-bindings/interrupt-controller/arm-gic.h> + +/ { + compatible = "ambarella,cv75"; + interrupt-parent = <&gic>; + #address-cells = <2>; + #size-cells = <2>; + + cpus { + #address-cells = <1>; + #size-cells = <0>; + + cpu@0 { + compatible = "arm,cortex-a76"; + device_type = "cpu"; + reg = <0x000>; + enable-method = "psci"; + }; + + cpu@1 { + compatible = "arm,cortex-a76"; + device_type = "cpu"; + reg = <0x100>; + enable-method = "psci"; + }; + }; + + osc: oscillator { + compatible = "fixed-clock"; + #clock-cells = <0>; + clock-frequency = <24000000>; + clock-output-names = "osc"; + }; + + psci { + compatible = "arm,psci-0.2"; + method = "smc"; + }; + + soc { + compatible = "simple-bus"; + #address-cells = <2>; + #size-cells = <2>; + ranges; + + ahb@ffe0000000 { + compatible = "simple-bus"; + reg = <0xff 0xe0000000 0x0 0x01000000>; + ranges = <0xe0000000 0xff 0xe0000000 0x01000000>; + #address-cells = <1>; + #size-cells = <1>; + + s_scratchpad_syscon: scratchpad@e002e000 { + compatible = "ambarella,cv75-sec-scratchpad", "syscon"; + reg = <0xe002e000 0x1000>; + }; + }; + + apb@ffe4000000 { + compatible = "simple-bus"; + reg = <0xff 0xe4000000 0x0 0x01000000>; + ranges = <0xe4000000 0xff 0xe4000000 0x01000000>; + #address-cells = <1>; + #size-cells = <1>; + + uart0: serial@e4000000 { + compatible = "ambarella,cv75-uart", + "snps,dw-apb-uart"; + reg = <0xe4000000 0x1000>; + clocks = <&rct CV75_GCLK_UART0>; + interrupts = <GIC_SPI 170 IRQ_TYPE_LEVEL_HIGH>; + pinctrl-names = "default"; + pinctrl-0 = <&uart0_pins>; + reg-io-width = <4>; + reg-shift = <2>; + + status = "disabled"; + }; + + pinctrl: pinctrl@e4010000 { + compatible = "ambarella,cv75-pinctrl"; + reg = <0xe4010000 0x1000>; + ambarella,drive-strength-syscon = <&rct>; + ambarella,pull-syscon = <&s_scratchpad_syscon>; + + uart0_pins: uart0-pins { + function = "uart0"; + groups = "uart0"; + }; + }; + + gpio0: gpio@e4013000 { + compatible = "ambarella,cv75-gpio", "arm,primecell"; + reg = <0xe4013000 0x1000>; + clocks = <&rct CV75_GCLK_APB>; + clock-names = "apb_pclk"; + interrupts = <GIC_SPI 163 IRQ_TYPE_LEVEL_HIGH>; + gpio-controller; + #gpio-cells = <2>; + gpio-ranges = <&pinctrl 0 0 32>; + interrupt-controller; + #interrupt-cells = <2>; + arm,primecell-periphid = <0x00000061>; + }; + + gpio1: gpio@e4014000 { + compatible = "ambarella,cv75-gpio", "arm,primecell"; + reg = <0xe4014000 0x1000>; + clocks = <&rct CV75_GCLK_APB>; + clock-names = "apb_pclk"; + interrupts = <GIC_SPI 164 IRQ_TYPE_LEVEL_HIGH>; + gpio-controller; + #gpio-cells = <2>; + gpio-ranges = <&pinctrl 0 32 32>; + interrupt-controller; + #interrupt-cells = <2>; + arm,primecell-periphid = <0x00000061>; + }; + + gpio2: gpio@e4015000 { + compatible = "ambarella,cv75-gpio", "arm,primecell"; + reg = <0xe4015000 0x1000>; + clocks = <&rct CV75_GCLK_APB>; + clock-names = "apb_pclk"; + interrupts = <GIC_SPI 165 IRQ_TYPE_LEVEL_HIGH>; + gpio-controller; + #gpio-cells = <2>; + gpio-ranges = <&pinctrl 0 64 32>; + interrupt-controller; + #interrupt-cells = <2>; + arm,primecell-periphid = <0x00000061>; + }; + }; + + rct: clock-controller@ffed080000 { + compatible = "ambarella,cv75-rct", "syscon"; + reg = <0xff 0xed080000 0x0 0x1000>; + clocks = <&osc>; + clock-names = "osc"; + #clock-cells = <1>; + assigned-clocks = <&rct CV75_GCLK_UART0>; + assigned-clock-parents = <&osc>; + assigned-clock-rates = <24000000>; + }; + + gic: interrupt-controller@fff0101000 { + compatible = "arm,gic-400"; + reg = <0xff 0xf0101000 0x0 0x1000>, + <0xff 0xf0102000 0x0 0x2000>, + <0xff 0xf0104000 0x0 0x2000>, + <0xff 0xf0106000 0x0 0x2000>; + interrupt-controller; + #interrupt-cells = <3>; + #address-cells = <0>; + #size-cells = <1>; + interrupts = <GIC_PPI 9 + (GIC_CPU_MASK_SIMPLE(2) | IRQ_TYPE_LEVEL_HIGH)>; + }; + }; + + timer { + compatible = "arm,armv8-timer"; + interrupts = <GIC_PPI 13 (GIC_CPU_MASK_SIMPLE(2) | IRQ_TYPE_LEVEL_LOW)>, + <GIC_PPI 14 (GIC_CPU_MASK_SIMPLE(2) | IRQ_TYPE_LEVEL_LOW)>, + <GIC_PPI 11 (GIC_CPU_MASK_SIMPLE(2) | IRQ_TYPE_LEVEL_LOW)>, + <GIC_PPI 10 (GIC_CPU_MASK_SIMPLE(2) | IRQ_TYPE_LEVEL_LOW)>, + <GIC_PPI 12 (GIC_CPU_MASK_SIMPLE(2) | IRQ_TYPE_LEVEL_LOW)>; + }; +}; diff --git a/arch/arm64/configs/defconfig b/arch/arm64/configs/defconfig index ad3bd3d9507b..454f07a6a6a6 100644 --- a/arch/arm64/configs/defconfig +++ b/arch/arm64/configs/defconfig @@ -36,6 +36,7 @@ CONFIG_CRASH_DUMP=y CONFIG_ARCH_ACTIONS=y CONFIG_ARCH_AIROHA=y CONFIG_ARCH_SUNXI=y +CONFIG_ARCH_AMBARELLA=y CONFIG_ARCH_ALPINE=y CONFIG_ARCH_APPLE=y CONFIG_ARCH_ARTPEC=y -- 2.34.1