Re: [PATCH 10/10] ARM: dts: qcom: apq8074-dragonboard: enable the HSIC host

Abel Vesa <[email protected]>
Newsgroups org.kernel.vger.linux-gpio,org.infradead.lists.linux-phy,org.kernel.vger.linux-arm-msm,org.kernel.vger.linux-devicetree,org.kernel.vger.linux-kernel,org.kernel.vger.linux-usb
Message-ID <unxuswp7lghhaa64rcerxdxi3n3sc6oz3iket6mf4z7hqtji42@7temhlkxanse> 
On 26-08-10 18:42:14, Dmitry Baryshkov wrote:
> The dragonboard carries an SMSC USB4604 HSIC hub, but with the HSIC
> controller undescribed the whole HSIC-attached part of the board is
> dead.
> 
> Enable the HSIC controller. The USB4604 hub isn't controllable through
> the I2C because of the board design issues, so reference it as a simple
> USB device, describing the reset line.
> 
> Assisted-by: Claude:claude-fable-5
> Signed-off-by: Dmitry Baryshkov <[email protected]>

Reviewed-by: Abel Vesa <[email protected]>
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.