Re: [PATCH 09/10] ARM: dts: qcom: msm8974: add the HSIC USB controller

Abel Vesa <[email protected]>
Newsgroups org.kernel.vger.linux-gpio,org.infradead.lists.linux-phy,org.kernel.vger.linux-arm-msm,org.kernel.vger.linux-devicetree,org.kernel.vger.linux-kernel,org.kernel.vger.linux-usb
Message-ID <oocip6a35iv7wsxtiudapckeklgv34d3cigftdc76jinixxy37@qdd7xsjxvkjf> 
On 26-08-10 18:42:13, Dmitry Baryshkov wrote:
> The MSM8974 HSIC USB host - a third Chipidea controller with a
> dedicated HSIC PHY on the special hsic_strobe/hsic_data pads - is not
> described, leaving boards with HSIC-attached hubs or modems without
> upstream support.
> 
> Add the controller and PHY nodes. The PHY is a ULPI bus driver present
> inside the ulpi subnode.
> 
> Assisted-by: Claude:claude-fable-5
> Signed-off-by: Dmitry Baryshkov <[email protected]>

Reviewed-by: Abel Vesa <[email protected]>
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.