[PATCHv2 3/8] ata: sata_dwc_460ex: enable SATA interrupts only after IRQ handler is registered

sata_dwc_enable_interrupts() is called before platform_get_irq() and
ata_host_activate(), leaving the SATA controller's interrupt mask
enabled without a registered handler.  If a later step fails (irq
request, phy init, etc.) or if the controller asserts an interrupt
during probe, the irq line may fire with no handler, causing a
spurious interrupt storm.

Move sata_dwc_enable_interrupts() after ata_host_activate() so that
interrupts are only unmasked once the handler is registered and the
core is fully initialized.

Assisted-by: opencode:big-pickle
Signed-off-by: Rosen Penev <[email protected]>
---
 drivers/ata/sata_dwc_460ex.c | 5 ++---
 1 file changed, 2 insertions(+), 3 deletions(-)

diff --git a/drivers/ata/sata_dwc_460ex.c b/drivers/ata/sata_dwc_460ex.c
index 1561adea323a..43011789c75e 100644
--- a/drivers/ata/sata_dwc_460ex.c
+++ b/drivers/ata/sata_dwc_460ex.c
@@ -1165,9 +1165,6 @@ static int sata_dwc_probe(struct platform_device *ofdev)
 	/* Save dev for later use in dev_xxx() routines */
 	hsdev->dev = dev;
 
-	/* Enable SATA Interrupts */
-	sata_dwc_enable_interrupts(hsdev);
-
 	/* Get SATA interrupt number */
 	irq = platform_get_irq(ofdev, 0);
 	if (irq < 0)
@@ -1198,6 +1195,8 @@ static int sata_dwc_probe(struct platform_device *ofdev)
 	if (err)
 		dev_err(dev, "failed to activate host");
 
+	/* Enable SATA Interrupts */
+	sata_dwc_enable_interrupts(hsdev);
 	return 0;
 
 error_out:
-- 
2.55.0