Re: [PATCH v2 1/2] dt-bindings: iio: adc: ti,ads112c04: Add binding for ADS112C04

On Fri, 31 Jul 2026 10:58:24 +0800, Kyle Hsieh wrote:
> Add device tree binding documentation for Texas Instruments ADS112C04
> I2C Analog-to-Digital Converters.
> 
> These devices provide 4-channel, 16-bit delta-sigma ADCs with an I2C
> interface, programmable gain amplifier (PGA), and data-ready (DRDY)
> interrupt output.
> 
> The binding uses child nodes to dynamically define the connected
> single-ended or differential channels.
> 
> Signed-off-by: Kyle Hsieh <[email protected]>
> ---
>  .../devicetree/bindings/iio/adc/ti,ads112c04.yaml  | 122 +++++++++++++++++++++
>  1 file changed, 122 insertions(+)
> 

My bot found errors running 'make dt_binding_check' on your patch:

yamllint warnings/errors:

dtschema/dtc warnings/errors:
/builds/robherring/dt-review-ci/linux/Documentation/devicetree/bindings/iio/adc/ti,ads112c04.yaml: properties:ti,refp-refn-resistor-ohms: '$ref' should not be valid under {'const': '$ref'}
	hint: Standard unit suffix properties don't need a type $ref
	from schema $id: http://devicetree.org/meta-schemas/core.yaml

doc reference errors (make refcheckdocs):

See https://patchwork.kernel.org/project/devicetree/patch/[email protected]

The base for the series is generally the latest rc1. A different dependency
should be noted in *this* patch.

If you already ran 'make dt_binding_check' and didn't see the above
error(s), then make sure 'yamllint' is installed and dt-schema is up to
date:

pip3 install dtschema --upgrade

Please check and re-submit after running the above command yourself. Note
that DT_SCHEMA_FILES can be set to your schema file to speed up checking
your schema. However, it must be unset to test all examples with your schema.