Re: [PATCH 4/7] serial: qcom-geni: Use geni_se_set_rate() for source clock configuration

On 8/4/26 9:57 PM, Praveen Talari wrote:
> The driver calls dev_pm_opp_set_rate() directly on uport->dev to apply
> the computed source clock frequency, and dispatches baud rate handling
> through a per-variant dev_data->set_rate() callback that either
> recalculates the clock divider (Linux clock managed path) or selects
> a performance level via geni_se_set_perf_level() (SA8255P firmware
> managed path).

[...]

> +	geni_se_set_rate(&port->se, 0);

This ends up calling dev_pm_opp_set_rate(0) [i see this is an existing
bug in geni_se_resources_deactivate()], which removes the power vote,
but does nothing to the clock (neither set_rate nor disable_unprepare),
which will crash the platform

Both of these calls (new and existing) should be removed. Clocks will
be disabled by geni_se_clks_off() in geni_se_resources_deactivate().

Then, we should do dev_pm_set_opp(se->dev, NULL) *after* they are off
to remove any trailing OPP resources (i.e. icc votes defined in the OPP
table in our case)

Konrad