Re: [PATCH 7/7] i2c: qcom-geni: Use geni_se_set_rate() for setting source clock frequency

On 8/4/26 9:57 PM, Praveen Talari wrote:
> On the SA8255P platform there is no Linux clock handler for the SE source
> clock; resources are instead managed by firmware via a genpd performance
> domain. The I2C driver therefore relies on geni_se_set_rate() to apply the
> fixed 19.2 MHz source clock frequency expected by the SCL divider and
> counter values programmed by qcom_geni_i2c_conf().

[...]

> @@ -233,6 +233,10 @@ static int qcom_geni_i2c_conf(struct geni_se *se, unsigned long freq)
>  				 itr->clk_div, itr->t_high_cnt,
>  				 itr->t_low_cnt, itr->t_cycle_cnt);
>  
> +	ret = geni_se_set_rate(&gi2c->se, 19200000);
> +	if (ret)
> +		return ret;

This wasn't here before and the commit message only says something to the
amount of "it's necessary" - what's the difference?

Konrad