Error report as requested

Dear all.

during booting I found the following message:

An unexpected IO-APIC was found. If this kernel release is less than
<4>three months old please report this to [email protected]

So I witte this mail
Please find below the part from the boot.msg.

I found this as the system is quite unstabel and freeses from time to time 
(Really frees, nothing to do, even not reachable from outside.)

I run a Suse Linux 9.0
Kernel 2.4.199smp

PC:
Dell Dimensium
Pentium 4 2.8 GHz HT
1 G Ram

Best regards,

Thomas.



ENABLING IO-APIC IRQs
<4>Setting 2 in the phys_id_present_map
<6>...changing IO-APIC physical APIC ID to 2 ... ok.
<7>init IO_APIC IRQs
<7> IO-APIC (apicid-pin) 2-0, 2-13 not connected.
<6>..TIMER: vector=0x31 pin1=2 pin2=0
<7>number of MP IRQ sources: 41.
<7>number of IO-APIC #2 registers: 24.
<6>testing the IO APIC.......................
<4>
<7>IO APIC #2......
<7>.... register #00: 02000000
<7>.......    : physical APIC id: 02
<7>.......    : Delivery Type: 0
<7>.......    : LTS          : 0
<7>.... register #01: 00178020
<7>.......     : max redirection entries: 0017
<7>.......     : PRQ implemented: 1
<7>.......     : IO APIC version: 0020
<7>.... register #02: 00178020
<7>.......     : arbitration: 00
<4>An unexpected IO-APIC was found. If this kernel release is less than
<4>three months old please report this to [email protected]
<7>.... IRQ redirection table:
<7> NR Log Phy Mask Trig IRR Pol Stat Dest Deli Vect:
<7> 00 000 00  1    0    0   0   0    0    0    00
<7> 01 003 03  0    0    0   0   0    1    1    39
<7> 02 003 03  0    0    0   0   0    1    1    31
<7> 03 003 03  0    0    0   0   0    1    1    41
<7> 04 003 03  0    0    0   0   0    1    1    49
<7> 05 003 03  0    0    0   0   0    1    1    51
<7> 06 003 03  0    0    0   0   0    1    1    59
<7> 07 003 03  0    0    0   0   0    1    1    61
<7> 08 003 03  0    0    0   0   0    1    1    69
<7> 09 003 03  0    0    0   0   0    1    1    71
<7> 0a 003 03  0    0    0   0   0    1    1    79
<7> 0b 003 03  0    0    0   0   0    1    1    81
<7> 0c 003 03  0    0    0   0   0    1    1    89
<7> 0d 000 00  1    0    0   0   0    0    0    00
<7> 0e 003 03  0    0    0   0   0    1    1    91
<7> 0f 003 03  0    0    0   0   0    1    1    99
<7> 10 003 03  1    1    0   1   0    1    1    A1
<7> 11 003 03  1    1    0   1   0    1    1    A9
<7> 12 003 03  1    1    0   1   0    1    1    B1
<7> 13 003 03  1    1    0   1   0    1    1    B9
<7> 14 003 03  1    1    0   1   0    1    1    C1
<7> 15 003 03  1    1    0   1   0    1    1    C9
<7> 16 003 03  1    1    0   1   0    1    1    D1
<7> 17 003 03  1    1    0   1   0    1    1    D9
<7>IRQ to pin mappings:
<7>IRQ0 -> 0:2
<7>IRQ1 -> 0:1
<7>IRQ3 -> 0:3
<7>IRQ4 -> 0:4
<7>IRQ5 -> 0:5
<7>IRQ6 -> 0:6
<7>IRQ7 -> 0:7
<7>IRQ8 -> 0:8
<7>IRQ9 -> 0:9
<7>IRQ10 -> 0:10
<7>IRQ11 -> 0:11
<7>IRQ12 -> 0:12
<7>IRQ14 -> 0:14
<7>IRQ15 -> 0:15
<7>IRQ16 -> 0:16
<7>IRQ17 -> 0:17
<7>IRQ18 -> 0:18
<7>IRQ19 -> 0:19
<7>IRQ20 -> 0:20
<7>IRQ21 -> 0:21
<7>IRQ22 -> 0:22
<7>IRQ23 -> 0:23
<6>.................................... done.
<4>Using local APIC timer interrupts.
<4>calibrating APIC timer ...
<4>..... CPU clock speed is 2792.0637 MHz.
<4>..... host bus clock speed is 199.0473 MHz.
<4>cpu: 0, clocks: 199473, slice: 66491
<4>CPU0<T0:199472,T1:132976,D:5,S:66491,C:199473>
<4>cpu: 1, clocks: 199473, slice: 66491
<4>CPU1<T0:199472,T1:66480,D:10,S:66491,C:199473>
<4>checking TSC synchronization across CPUs: passed.
<4>migration_task 0 on cpu=0
<4>migration_task 1 on cpu=1
<6>ACPI: Subsystem revision 20030619
<6>ACPI: Disabled via command line (acpi=off)
<6>PCI: PCI BIOS revision 2.10 entry at 0xfbb18, last bus=2
<6>PCI: Using configuration type 1
<6>PCI: Probing PCI hardware
<4>PCI: Probing PCI hardware (bus 00)
<6>PCI: Ignoring BAR0-3 of IDE controller 00:1f.1
<4>Transparent bridge - Intel Corp. 82801BA/CA/DB/EB PCI Bridge
<6>PCI: Using IRQ router PIIX [8086/24d0] at 00:1f.0
<6>PCI->APIC IRQ transform: (B0,I29,P0) -> 16
<6>PCI->APIC IRQ transform: (B0,I29,P1) -> 19
<6>PCI->APIC IRQ transform: (B0,I29,P2) -> 18
<6>PCI->APIC IRQ transform: (B0,I29,P0) -> 16
<6>PCI->APIC IRQ transform: (B0,I29,P3) -> 23
<6>PCI->APIC IRQ transform: (B0,I31,P0) -> 18
<6>PCI->APIC IRQ transform: (B0,I31,P0) -> 18
<6>PCI->APIC IRQ transform: (B0,I31,P1) -> 17
<6>PCI->APIC IRQ transform: (B1,I0,P0) -> 16
<6>PCI->APIC IRQ transform: (B2,I1,P0) -> 22
<6>PCI->APIC IRQ transform: (B2,I2,P0) -> 17
<6>PCI->APIC IRQ transform: (B2,I8,P0) -> 20
<6>Linux NET4.0 for Linux 2.4
<6>Based upon Swansea University Computer Society NET3.039
<4>Initializing RT netlink socket
<6>apm: BIOS version 1.2 Flags 0x03 (Driver version 1.16)
<5>apm: disabled - APM is not SMP safe (power off active).
<4>Starting kswapd
<4>bigpage subsystem: allocated 0 bigpages (=0MB).
<4>allocated 32 pages and 32 bhs reserved for the highmem bounces
<4>kinoded started