Re: [meta-freescale] imx51evk and u-boot

Fabio Estevam <[email protected]> Sat, 11 Jun 2022 17:33:15 -0300

Newsgroups	org.yoctoproject.lists.meta-freescale
Message-ID	<CAOMZO5Apkf1EnyfXuprE9cn+eajGhdjPMU6OeRPFMXVnWCWPRg@mail.gmail.com>

On Sat, Jun 11, 2022 at 2:50 PM Otavio Salvador
<[email protected]> wrote:

>> I'm trying to build Yocto dunfell for imx51evk derived board.
>>
>> The board has only sd card with 1 dram of ram.

imx51evk has 512MB of RAM.

You need to adapt the DDR for your specific board to be able to boot it.

> It has been ages since I used those. @Fabio Estevam have you tried them lately?

Yes, it boots well with the top of tree U-Boot:

U-Boot 2022.07-rc4-00007-g57bd363de7 (Jun 11 2022 - 17:26:16 -0300)

CPU:   Freescale i.MX51 rev3.0 at 800 MHz
Reset cause: POR
Model: Freescale i.MX51 Babbage Board
Board: MX51EVK
DRAM:  512 MiB
Core:  20 devices, 9 uclasses, devicetree: separate
MMC:   FSL_SDHC: 0, FSL_SDHC: 1
Loading Environment from MMC... OK
In:    serial
Out:   serial
Err:   serial
Net:   No ethernet found.
Hit any key to stop autoboot:  0