Re: Setup help

Gary,

You might want to check the "advanced" settings on your mixer application
for your sound card.  Many have a microphone boost checkbox that ups the
gain on the mic input by 10 or 20 dB. You might also consider switching
microphones.

 Make sure your WAV volume is turned up and its mute checkbox is unchecked.
Same goes for the Microphone and the master volume control.

Kevin

----- Original Message ----- 
From: "Gary Fritz" <[email protected]>
To: <[email protected]>
Sent: Sunday, September 07, 2003 12:30
Subject: [speak-freely] Setup help


> I apologize if this request is inappropriate to this list -- from
> looking at the archives, it appears the list is mostly used for
> discussion of SF's aim and implementation -- but I'm not quite
> sure where to go next.  Any pointers would be appreciated.
>
> I just installed SF on a Windows 2000 system, and I can't get any
> audio into it.  I verified that my microphone and audio card work
> properly with the Windows Sound Recorder.  The levels are low
> (even though the mic record level is set to max in the Windows
> Volume Control) but it does work.  (I checked that the microphone
> is plugged into the mic in jack, not the line in.)  But SF
> doesn't receive any audio at all.  Local Loopback doesn't echo
> anything, and the Audio Monitor doesn't show any input.
>
> The online help doesn't offer many troubleshooting tips.  Are
> there any websites that help?
>
> Thanks,
> Gary
>
>
>                       * * *
>
> To unsubscribe from this mailing list, send E-mail containing
> the word "unsubscribe" in the message body (*not* as the
> Subject) to [email protected]
>



                      * * *

To unsubscribe from this mailing list, send E-mail containing
the word "unsubscribe" in the message body (*not* as the
Subject) to [email protected]