Re: Setup help

I installed SF on a second W2k system to see if I could get it 
working there.  On that system I can get the loopback to work.  I 
still get no response from either of two echo-back servers.  The 
Spectrum and Envelope windows show signal going out, but nothing 
coming back.

> You will see "junk" going by on the spectrum analyzer graph most of
> the time.  This is just the system noise generated by your computer
> motherboard and power supply that gets into your audio card.
> Typically, the noise level is low enough where it won't register on
> the envelope graph. 

I must have a noisy system.  On the second PC, the background 
noise registers at about 87%.  Makes it difficult to use the VOX.

> If you don't see a horizontal line when whistling, then you are just
> looking at noise and you have an audio hardware or mixer problem. 

I see a proper signal, which you'd expect since the local 
loopback works.

Gary


                      * * *

To unsubscribe from this mailing list, send E-mail containing
the word "unsubscribe" in the message body (*not* as the
Subject) to [email protected]