Re: Wireless adapter for new computer re TUNTAP
| Newsgroups | gmane.comp.emulators.hercules390.general |
|---|---|
| Message-ID | <CAPcd4G9nkbgx3xifzmogmZwk1_-jSOfk7HHEe-hEsO=MbmfMNQ@mail.gmail.com> |
Most people arent using WinPCap anymore, its long been out of maintenance, since 2013. Its been replaced by the new NPCap driver which uses the NDIS 6 interfaces. It also has support for capturing 802.11 frames in monitor mode. https://nmap.org/npcap/vs-winpcap.html Joe On Sat, Jun 15, 2019 at 3:18 AM ''Fish' (David B. Trout)' [email protected] [hercules-390] <[email protected]> wrote: > > > Joe Reichman wrote: > > > would anyone know if the following wireless adapter > > works with tuntap/winpcap intel Killer AX1650 > > Anyone who had bothered to read the "Wireless Networking" section of the > "Common Problems" chapter of the CTCI-WIN product Help file would know: > > "Wireless Networking" > > "CTCI-WIN does not work with wireless network adapters. > This is a limitation of the WinPCap device driver > which only supports 802.3 format packets." > > "Wireless adapters send and receive 802.11 format packets > which are completely different. Wireless adapters are > completely different hardware devices from wired adapters, > and device drivers for one type of hardware obviously > cannot be used for the other type." > > "You can still wirelessly connect to Hercules for 3270 > terminal access for example, but you cannot use your > wireless adapter for Hercules networking (i.e. you cannot > use your wireless adapter for your e.g. Hercules CTCI > or LCS or QETH/OSA devices)." > > "If you have both types of network adapters on your computer > you also need to make sure the wired adapter is bound ahead > of your wireless adapter (i.e. your wired adapter needs to > come before your wireless adapter in Windows's network > adapter binding order). To change the binding order of your > network adapters please refer to the instructions provided > in the "Change the binding order of your adapters" chapter." > > "If you are running Windows 10 however, the adapter binding > order cannot be changed so you must instead define a default > CTCI-WIN adapter as explained in the "Defining a default > CTCI-WIN adapter" chapter." > > -- > "Fish" (David B. Trout) > Software Development Laboratories > http://www.softdevlabs.com > mail: [email protected] > > >