Re: gkrellm vs asus mobo's

On 14.05.2010 05:36, Gene Heskett wrote:
>
> root@coyote amanda]# sensors
> acpitz-virtual-0
> Adapter: Virtual device
> temp1:       +40.0°C  (crit = +75.0°C)
>
> atk0110-acpi-0
> Adapter: ACPI interface
> Vcore Voltage:          +1.29 V  (min =  +0.85 V, max =  +1.60 V)
>   +3.3 Voltage:          +3.40 V  (min =  +3.00 V, max =  +3.60 V)
>   +5.0 Voltage:          +5.11 V  (min =  +4.50 V, max =  +5.50 V)
> +12.0 Voltage:         +12.31 V  (min = +11.20 V, max = +13.20 V)
> CPU FAN Speed:         3857 RPM  (min =    0 RPM)
> CHASSIS FAN Speed:        0 RPM  (min =    0 RPM)
> POWER FAN Speed:          0 RPM  (min =    0 RPM)
> CHASSIS4 FAN FAN Speed:4295 RPM  (min =    0 RPM)
> CHASSIS2 FAN FAN Speed:   0 RPM  (min =    0 RPM)
> CHASSIS3 FAN FAN Speed:1654 RPM  (min =    0 RPM)
> CPU Temperature:        +45.0°C  (high = +90.0°C, crit = +125..0°C)
> MB Temperature:         +37.0°C  (high = +45.0°C, crit = +90.0°C)
>

Any sensor shown by the lm-sensors commandline tool should also be 
visible through libsensors. It probably depends on wether your gkrellm 
was compiled with or without libsensors-support. Eventually running 
"gkrellm -d 1" could reveal some information about which sensor-backend 
is used in gkrellm (IIRC gkrellm on linux has several ways for reading 
sensors, including libsensors and sysfs).

Bye,
Stefan

______________________________________________
Gkrellm mailing list
[email protected]
Read archives-join-leave-set RSS feed:
http://archive.lists.netservicesgroup.com
This service is provided by The Network Services Group:
http://www.netservicesgroup.com