Scandisk Connect + DHCP not working

Hi, I just got a Scandisk Connect+ card. I followed the tutorial on the 
OpenZaurus wiki to get it installed. The card seemed to install fine. I 
can use the network settings app to scan the network for access points and 
it finds my access point. My problem is that once I have the card 
configured with my essid, I can't get dhcp to get a lease. I've tried 
installing dhclient. When I run dhclient it hangs. I've tried configuring 
the interface manualy with iwconfig and dhclient but have had no luck.


Any ideas?

Yolan

*************************************************
* Yolan (Aaron Jackson) yolan-c4vwXAgtg5/[email protected] *
*       http://mlug.missouri.edu/~yolan/        *
*    AIM: YolanLINUX, YolanOTHER, YolanLAPTOP   *
*                 ICQ: 74624109                 *
*************************************************
             *  Doubling Technologies *
             **************************


-------------------------------------------------------------------------
Take Surveys. Earn Cash. Influence the Future of IT
Join SourceForge.net's Techsay panel and you'll get the chance to share your
opinions on IT & business topics through brief surveys -- and earn cash
http://www.techsay.com/default.php?page=join.php&p=sourceforge&CID=DEVDEV