Re: lircd lockup on raspberry pi

On 31/08/17 03:34, sean d'epagnier wrote:

> When I build the latest version from source,

master branch, right?

> and run "irw" I do get a
> reading from the first button pressed on the remote, but then lircd
> consumes 100% cpu, and is  unresponsive.  No more buttons are reported
> by irw.
> 
> If I kill lircd, and restart it, it works again, for just 1 button press.
> 
> Using lirc version 9.0.0 there is no problem.
> 
> Has anyone seen this?

If you tried the master branch: could you please try the release-0.10 
branch instead?



Cheers!

--alec

------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot