Re: [EE] Intentionally delaminating a PCB

Jason White <[email protected]>
Newsgroups gmane.comp.hardware.microcontrollers.pic
Message-ID <CAOFvGD4Y59BJaMK=r7_JpUFOqKG+o4G4AjHjd+macv0Jon9jSA@mail.gmail.com> 
Consider spending the time to properly XRAY it first (get the exposure and
focus correct) before doing anything destructive.

A local machine shop could run it through a surface grinder very easily
(clamp it flat, then remove 5 microns per grinding pass in sections)

-- 
Jason White
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.