Debug over USB-parallel adaptor
"ronw_mrmx" <[email protected]>
| Newsgroups | gmane.comp.hardware.motorola.microcontrollers |
|---|---|
| Message-ID | <[email protected]> |
I'm doing development with the Phytec MCP555 development kit and
Codewarrior 8.1.
At the office, I have a tower PC with a parallel port that I can use
for debugging with the Phytec board. Now I need to go to a factory
environment to test with the prototype hardware (which also uses the
Phytec board).
Unfortunately, the available laptop PC has no parallel port - only USB
ports. Before I go out and get one, it it even possible to make this
work using a USB-parallel adaptor? If so, which ones will work?
------------------------ Yahoo! Groups Sponsor --------------------~-->
Most low income households are not online. Help bridge the digital divide today!
http://us.click.yahoo.com/cd_AJB/QnQLAA/TtwFAA/dN_tlB/TM
--------------------------------------------------------------------~->
-----------------------------------------------------------
To learn more about Freescale Microcontrollers, please visit
http://www.freescale.com/mcu
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/MPC500/
<*> To unsubscribe from this group, send an email to:
[email protected]
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/