Re: Converting a BigIP from Active/Standby to Active/Active
Hamish Marson <[email protected]> Thu, 19 Nov 2009 20:06:55 +0000
| Newsgroups | gmane.comp.programming.load-balancing.general |
|---|---|
| Message-ID | <[email protected]> |
On 19 Nov 2009, at 19:45, Justin Huff wrote: > Howdy! > > I have a need to convert my BigIP LTM from A/S to A/A. F5's docs say > that it's best to reinstall. I could probably do that..but how bad > would it be do change the redundancy mode without a reinstall? > > I was thinking of doing it this way: > 1. make sure that node #1 was active (since all the resources default to 1) > 2. change the mode on #1 > 3. Config Sync to node 2 > 4. Profit?!?! > That's the way I did it... I swapped back & forth several time. I'm not sure why anyone would say re-install... H _______________________________________________ lb-l mailing list [email protected] http://vegan.net/mailman/listinfo/lb-l Searchable Archive: http://vegan.net/lb/archive http://lbdigest.com Load Balancing Digest http://lbwiki.com Load Balancing Wiki