Re: [CinePaint] ICC Examin plugin

Kai-Uwe Behrmann píše v Pá 22. 08. 2008 v 20:58 +0200:
> Am 17.08.08, 21:06 +0200 schrieb Milan Knížek:
> > When "Print Proof" is not selected, the image colours are shown as per
> > the image profile. When "Print Proof" is selected, the image colours are
> > shown after transformation to the printer profile - i.e. they fit in the
> > smaller printer gamut.
> 
> ... and they should show a tracing line of the colour movement.
...
> a pixel only representation. The tracing lines are more verbose about 
> this movement. Switch print simulation on and of, or switch between 
> different rendering intents to make those lines visible.

Thanks Kai-Uwe - I had not gotten the point of switching print proof
off/on _while_ ICC Examin is running - earlier I had done this before
the plugin was run which showed only the image pixels as dots in the
respective (embedded, printer) gamut.

Best regards,

Milan Knizek
knizek (dot) confy (at) volny (dot) cz
http://www.milan-knizek.net - about linux and photography


-------------------------------------------------------------------------
This SF.Net email is sponsored by the Moblin Your Move Developer's challenge
Build the coolest Linux based applications with Moblin SDK & win great prizes
Grand prize is a trip for two to an Open Source event anywhere in the world
http://moblin-contest.org/redirect.php?banner_id=100&url=/
_______________________________________________
Cinepaint-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/cinepaint-users