Re: Difficulty with PSC 1210

bbales wrote:
> 
> The command line is "lp -s -dpsc1210" in the gimp print menu.  Not sure what 
> you mean about running gimp from the command line.  I typed 
> "lp -s -dpsc1210 kfc2.jpg" in a console.  Came right back with the prompt and 
> printer didn't move.
> bruce
> 

So "lp -s -dpsc1210 kfc2.jpg" did not cause any error message on your 
console?

Can you post the output of the following commands:

lpstat -o
lpstat -p
lpstat -v
lpinfo -v
ps auxwww | grep hp

Can you also set the "LogLevel" to "debug" in /etc/cups/cupsd.conf, 
restart CUPS, send the job again, and then observe what gets loggen in 
/var/log/cups/error_log? Have also the toolbox (/usr/hplip/toolbox or 
/usr/local/hplip/toolbox) running and observe the messages on the status 
tab.

    Till


-------------------------------------------------------
SF email is sponsored by - The IT Product Guide
Read honest & candid reviews on hundreds of IT Products from real users.
Discover which products truly live up to the hype. Start reading now. 
http://productguide.itmanagersjournal.com/