Re: No led

Am Dienstag, 21. November 2006 10:38 schrieb Stefan Schmidt:

> Good to know, perhaps a start point.
>
> Have you changed anything in the code? You need to load the module
> with led=1?

No. I'm using the Linux kernel driver without any changes. The only module 
parameter I'm using is "associate=0".

> The most important question could be if it was a ipw card listed in
> the IBM Bios PC ID listings? My ipw2915 was not listed, so i had to
> change the bit allowing me booting with this card.

It is an IBM compatible card. The only thing I changed was the region code, 
because I bought it in the USA and wanted to use it in Germany.

regards,
Jörg

-- 
PGP Key: send mail with subject 'SEND PGP-KEY' PGP Key-ID: FD 4E 21 1D
PGP Fingerprint: 388A872AFC5649D3 BCEC65778BE0C605


-------------------------------------------------------------------------
Take Surveys. Earn Cash. Influence the Future of IT
Join SourceForge.net's Techsay panel and you'll get the chance to share your
opinions on IT & business topics through brief surveys - and earn cash
http://www.techsay.com/default.php?page=join.php&p=sourceforge&CID=DEVDEV