Re: Lots of RX errors... ??? ...

Jason Boerner <[email protected]> Thu, 24 Apr 2003 13:38:13 -0700
Newsgroups gmane.linux.drivers.tulip.general
Message-ID <[email protected]>
>
>
>Delete the dmfe driver and add another $10 PCI NIC.
>
Good Point!  :-)

What is your favorite cheap NIC for a Linux box?



On 4/24/2003 1:25 PM, Donald Becker wrote:

>On Thu, 24 Apr 2003, Jason Boerner wrote:
>
>  
>
>>I found out that Davicom does have a web site with a Linux driver for 
>>the DM9000 chip.  However, it was last updated on 2001/11/09.
>>    
>>
>
>The driver in the kernel derives from that source, but has been updated
>to newer APIs and to fix obvious bugs.  It hasn't been reworked to fix
>the structural problems.
>
>  
>
>>Does anyone have experience with this driver or know of an update?
>>    
>>
>
>I briefly tried to use the dmfe driver on a local server that had the
>chip on the motherboard, but the bugs were too severe for the hour or
>two that I spent on it.
>
>  
>
>>Hmmm...  Actually, how do I verify that the chip on this MB is a 9000 
>>and not something else?
>>    
>>
>
>You can use 'lspci -vn' or 'cat /proc/pci' to find this information.  (It
>is, based on your previous report.)
>
>  
>
>>This is for a low throughput home firewall box, so I would hate to swap 
>>out the MB just because of the bad built in NIC.
>>    
>>
>
>Delete the dmfe driver and add another $10 PCI NIC.
>
>  
>

_______________________________________________
tulip mailing list, [email protected]
To change to digest mode or unsubscribe visit
http://www.scyld.com/mailman/listinfo/tulip