Re: Linksys PCMPC200 CardBus - problems with tulip.c compilation

On Sat, 25 Oct 2003, Michal Kepien wrote:

> OK, I switched to 'direct hardware access via Intel configuration
> mechanism 1' (`lspci -v -H1`) and here are the results (I excluded all
> the not-PCMCIA-linked devices):
...
> :14:00.0 Ethernet controller: Unknown device 1737:ab09 (rev 11)
> :	Subsystem: Unknown device 1737:ab09
> :	Flags: medium devsel
> :	I/O ports at <unassigned> [disabled]
> :	Memory at 60000000 (32-bit, non-prefetchable)
> :	Capabilities: [c0] Power Management version 2
> 
> Something tells me ;) that the problem is hidden in the "Unknown
> device 1737:ab09" line...

No, that's not the problem at all.  The driver has 0xab091737 in the
detection list and will recognize the device.

The problem is that the PCMCIA/CardBus subsystem did not provide
"resources" such as an IRQ and I/O address mapping.

There is likely an error message indicating why...

-- 
Donald Becker				[email protected]
Scyld Computing Corporation		http://www.scyld.com
914 Bay Ridge Road, Suite 220		Scyld Beowulf cluster system
Annapolis MD 21403			410-990-9993

_______________________________________________
tulip mailing list, [email protected]
To change to digest mode or unsubscribe visit
http://www.scyld.com/mailman/listinfo/tulip