Re: Support for Radeon 9100 IGP-integrated 3c920?
Ian Anderson <[email protected]> Mon, 15 Dec 2003 19:07:46 -0500
| Newsgroups | gmane.linux.drivers.vortex.devel |
|---|---|
| Message-ID | <1071533266.3653.1.camel@dhcppc1> |
gcc32 worked ;-) vortex-diag.c:v2.14 12/28/2002 Donald Becker ([email protected]) http://www.scyld.com/diag/index.html Assuming a 3Com Generic Vortex/Boomerag/Cyclone adapter at 0xd480. Station address 00:0e:a6:11:f3:92. Receive mode is 0x07: Normal unicast and all multicast. Indication enable is 0000, interrupt enable is 0000. No interrupt sources are pending. Transceiver/media interfaces available: MII. Transceiver type in use: MII. MAC settings: half-duplex. Station address set to 00:0e:a6:11:f3:92. Configuration options 0052. Saved EEPROM settings of a 3Com Vortex/Boomerang: 3Com Node Address 00:0E:A6:11:F3:92 (used as a unique ID only). OEM Station address 00:0E:A6:11:F3:92 (used as the ethernet address). Device ID 9202, Manufacturer ID 6d50. Manufacture date (MM/DD/YYYY) 0/4/2002, division 2, product No BIOS ROM is present. Transceiver selection: MII. Options: negotiated duplex, link beat required. PCI Subsystem IDs: Vendor 1043 Device 8108. MII. Vortex format checksum is incorrect (55 vs. 1043). Cyclone format checksum is incorrect (0xcf vs. 0xe4). Hurricane format checksum is correct (0xe4 vs. 0xe4). MII PHY found at address 1, status 786d. MII PHY 0 at #1 transceiver registers: 3100 786d 0000 8201 01e1 45e1 0001 0000 0000 0000 0000 0000 0000 0000 0000 0000 000c 0080 0000 0023 0c59 0406 0200 8560 8a7b 01f9 0000 0000 0000 0000 0000 0000. On Mon, 2003-12-15 at 18:51, Bogdan Costescu wrote: > On Mon, 15 Dec 2003, Ian Anderson wrote: > > > There is a hole in my bucket.......any tips for getting it to compile > > with gcc 3.3.2 under Fedora Core 1? > > Yes. Use "gcc32" instead of "gcc". As there seem to be some problems with > gcc 3.3 compiling the Linux kernel, Red Hat has shipped gcc 3.2 for > (re-)compiling kernels; if you don't have it installed, look it up on the > CDs. > > The problem with vortex-diag might be related to the multi-line strings > that are not allowed anymore: first line of > > http://gcc.gnu.org/gcc-3.3/changes.html -- Ian _______________________________________________ vortex mailing list [email protected] http://www.scyld.com/mailman/listinfo/vortex