Re: Support for Radeon 9100 IGP-integrated 3c920?

Output from /var/log/messages when restarting network:
Dec 15 18:56:29 localhost network: Bringing up loopback interface: 
succeeded
Dec 15 18:56:29 localhost ifup:
Dec 15 18:56:29 localhost ifup: Determining IP information for eth0...
Dec 15 18:56:35 localhost ifup:  failed; no link present.  Check cable?
Dec 15 18:56:35 localhost network: Bringing up interface eth0:  failed
Dec 15 18:56:35 localhost ifup: 3c59x device eth1 does not seem to be
present, delaying initialization.
Dec 15 18:56:35 localhost network: Bringing up interface eth1:  failed

On Mon, 2003-12-15 at 18:46, Bogdan Costescu wrote: 
> On Mon, 15 Dec 2003, Ian Anderson wrote:
> 
> > eth1 (ATI/3Com/Realtek) = Determining IP information for eth1... failed;
> > no link present.  Check cable?
> 
> This is the high level error. I asked in my previous message for logs: 
> lines from /var/log/messages (or whatever syslog is setup to write to) 
> and/or output of "dmesg".
> 
> > I'm not sure if part of the problem is because I have two 3Com cards in
> > one system,
> 
> No. I had 5 at one time (there were only 5 PCI slots on that mainboard...)

-- 
Ian

_______________________________________________
vortex mailing list
[email protected]
http://www.scyld.com/mailman/listinfo/vortex