RE: Redhat-ppp-list digest, Vol 1 #901 - 1 msg

I used minicom and tried following
 
AT S7=45 S0=0 L1 V1 X4 &c1 E1 Q0
OK
atz
OK
atdt6491398
BUSY
atdp6491398
BUSY
 
Does this mean that my line is not setup properly?
 


Kevin Smith <[email protected]> wrote:
> 01/11 16:51:49 yS0 checking lockfiles, locking the line
> 
> 01/11 16:51:49 yS0 makelock(ttyS0) called
> 
> 01/11 16:51:49 yS0 do_makelock: lock='/var/lock/LCK..ttyS0'
> 
> 01/11 16:51:49 yS0 lock made
> 
> 01/11 16:51:49 yS0 wfr: waiting for ``RING''
> 
> 01/11 16:51:49 yS0 got: [0a][0d][0a]RING[0d]
> 
> 01/11 16:51:49 yS0 CND: RING
> 
> 01/11 16:51:49 yS0 wfr: rc=0, drn=0
> 
> 01/11 16:51:49 yS0 CND: check no: 'none'
> 
> 
> 01/11 16:52:13 ##### failed A_FAIL dev=ttyS0, pid=931, caller='none',
> conn='', name=''
> 

ATA causes the modem to go into Answer mode, itll pick up and send a
carrier. What seems to be happening is thst its picking up the line,
sending a carrier but gotting no response and timing out. 

> !01/11 16:51:49 yS0 send: ATA[0d]
> 
> 01/11 16:51:49 yS0 waiting for ``CONNECT''
> 
> 01/11 16:51:49 yS0 got: ATA[0d]
> 
> 01/11 16:51:49 yS0 CND: OKATA[0d][0a]NO CARRIER
> 
> 01/11 16:52:13 yS0 found action string: ``NO CARRIER''

If you are tryin to dial-in, use atdt 
(for tone) or atdp

(for pulse).
Now if you want the modem to pick up when someone calls, set ATS0=x
(where x is the number of rings to wait unitl it picks up) 

Kev


> 
> 
> 
> Hello
> 
> 
> 
> Following is my mgetty debug, on USRobotics Courier I-Modem with
ISDN/V.34
> ISDN
> 
> Can someone guide me, why I am getting no carrier while I think line
is
> good and I also get connected.
> 
> 
> 


_______________________________________________
Redhat-ppp-list mailing list
[email protected]
https://www.redhat.com/mailman/listinfo/redhat-ppp-list

---------------------------------
Do you Yahoo!?
Yahoo! Hotjobs: Enter the "Signing Bonus" Sweepstakes