Re: (no subject)

Thankyou very much for the reply.

I tried this to no avail. It is ignoring 800 X 600 because it is not finding a suitable dot clock.
A range was found around 25 pixels per second, so it only works for 640 X 480.

When I try Driver "sis in the Devices section of XF86Config I get the server crashing with erro 
message "Unknown device driver keyword"
I even tried using XF86_SVGA server but this gave me a really low resolution!

Cheers,
Phil

17/12/2002 21:00:50, [email protected] wrote:

><PRE>Try setting up the horozontal and vertical sync for your monitor (can be 
>found on the internet or in your monitors manual). Enter the values in during 
>setup and see if you are able to see linux in a higher resolution.
>
>
>
>_______________________________________________
>Guinness-list mailing list
>[email protected]
>https://listman.redhat.com/mailman/listinfo/guinness-list
>
>