RE: RH S/390 7.2 install

Dave,

As I recommend to just about everyone, try running dasdfmt and mke2fs
manually.  To do this, you'll have to start up rhsetup and get to the point
where the DASD devices get defined.  (The Red Hat installation process
dynamically creates the entries in /dev after you tell it what volumes
you're using.)  When you get to that point, telnet in with a second session,
and do the "dasdfmt -b 4096 -f /dev/dasda" etc.

Mark Post


-----Original Message-----
From: David Heilman [mailto:[email protected]]
Sent: Friday, March 22, 2002 8:52 AM
To: [email protected]
Subject: [Redhat-s390-list] RH S/390 7.2 install


I am trying to install RedHat 7.2 S/390 in an LPAR and I can not get 
past the formatting of the disks. I have 2 disks defined to the LPAR and 
they look good if I do an auto sense. I have tried both the "loader" and 
"rhsetup" but still have problems with the format. Is there someone out 
there that has done this and could please help me.

TIA
Dave


_______________________________________________
Redhat-s390-list mailing list
[email protected]
https://listman.redhat.com/mailman/listinfo/redhat-s390-list

_______________________________________________
Redhat-s390-list mailing list
[email protected]
https://listman.redhat.com/mailman/listinfo/redhat-s390-list