Re: Xauthority with FC6
Dave Close <[email protected]>
| Newsgroups | gmane.mail.exmh.user |
|---|---|
| Message-ID | <[email protected]> |
[email protected] wrote: >No, the -si:localhost:$USER takes *away* that entry - to *add* an entry the >syntax is 'xhost +si:localhost:$USER'. My xhost output looked the same >as yours when I had the problem. Now it just says: > >% xhost >access control enabled, only authorized clients can connect >% > >(Note the *single* line of output now - careful reading of the Tk source >code reveals that the test Tk makes is, basically, "walk the same access >list as xhost does while printing it, and if xhost would list something >other than 'access control enabled', Tk complains". I'm embarrassed. I read that in the man page but just glossed over it. Thanks for your patience. Entering that command from an xterm, then restarting exmh, was enough to make it work! Now I'll try to find where to insert it for future automatic use. -- Dave Close, Compata, Costa Mesa CA "A difference has to make a [email protected], +1 714 434 7359 difference in order to be a [email protected] difference." --Wendell Johnson