RE: configuration of addresses on ipsec0.

Hi,

as I know that you are dealing quite heavily with IPv6, I assume that the=
 question is IPv6 related, even if not explicitly stated.

What version of IPv6-enabled FreeSWAN do you use?
I know we had this effect in older verions, but if I am not mistaken, we =
changed that in our later versions.

Best Regards,

	Gerhard

--------------------------------------------
Gerhard Ge=DFler

Communication Networks, IABG mbH
Einsteinstr. 20
85521 Ottobrunn, Germany

Telefon: +49 89 6088 - 2021
Fax: +49 89 6088 - 2845

E-Mail: [email protected]=20

  > -----Original Message-----
  > From: Kaustubh Kumbhalkar=20
  > [mailto:[email protected]]=20
  > Sent: Wednesday, April 09, 2003 7:03 AM
  > To: [email protected]; [email protected]
  > Subject: [Users] configuration of addresses on ipsec0.
  >=20
  >=20
  > hi
  > i am facing a problem w.r.t configuration of addresses on=20
  > ipsec0 dev. at the time i  give the command ipsec setup=20
  > start, there are multiple addresses configured on eth0=20
  > device. but pluto configures only one address on ipsec0=20
  > device which is the first address in the list. all the=20
  > addresses are valid globally routable unicast addresses.=20
  > another problem  is that when router advertisements are=20
  > recieved it configures the any new prefixes over ipsec0 and=20
  > not on eth0. what could be happening ?
  >=20
  > help pls
  >=20
  > kausty
  >=20
  > _______________________________________________
  > Users mailing list
  > [email protected]=20
  >   > http://lists.freeswan.org/mailman/listinfo/users
  >=20