check_http

Thanks for the response I recieved about my last question with reading a
url using check_http.  I still am running into a problem that I can't seem
to figure out.  I have verified on a test setup that my check works, but
when I run against the site I want to monitor, I get the following message.

HTTP ok: HTTP/1.1 302 Moved Temporarily - 0 second response time

Here is the command I am trying to run.

check_http <ip> -p 8080 -u <url> -r <string>

The problem is the command does not read for the string at all.  Doesn't
matter if I put a good or bogus string in I get the same response.  I tried
just running check_http with the ip and port option and I got the same
response.  So it seems like the problem is with the initial connection to
the server.  I've got a feeling this is being generated by some kind of
redirect.  Please let me know if anyone knows what this is and what I might
be able to do to resolve the issue.

Thanks,
Shawn Jones
[email protected]



The content of this email message and any attachments are confidential and may be legally privileged, intended solely for the addressee.  If you are not the intended recipient, be advised that any use, dissemination, distribution, or copying of this e-mail is strictly prohibited.  If you receive this message in error, please notify the sender immediately by reply email and destroy the message and its attachments.



-------------------------------------------------------
This sf.net email is sponsored by:ThinkGeek
Welcome to geek heaven.
http://thinkgeek.com/sf