check_ping command
"Marty Boyce" <[email protected]> Wed, 22 Jan 2003 13:45:02 -0700
| Newsgroups | gmane.network.netsaint.user |
|---|---|
| Message-ID | <se2ea067.061@CO-MS-099> |
Hello, I was wondering if anyone could help me with probably a simple problem. I cannot run the check_ping command from a command line. When I was installing Netsaint, I was compiling the binaries, and when it got to /bin/ping, it would lock up. Someone told me to put another switch on that said, "ping -n -c 1", and then it did not lock up anymore. But now, when I try to run the check_ping command, it gives me an error that says, "ping -n -c 1, error: could not interpret output from ping command". Can anyone help me with this? Thanks! Marty Boyce Young Living Essential Oils [email protected] 801-706-7789 ------------------------------------------------------- This SF.net email is sponsored by: Scholarships for Techies! Can't afford IT training? All 2003 ictp students receive scholarships. Get hands-on training in Microsoft, Cisco, Sun, Linux/UNIX, and more. www.ictp.com/training/sourceforge.asp