CRB on a Cisco 7206VXR

Hi Everyone,

I'm trying to set Concurrent Routing and Bridging on a Cisco 7206VXR 
router. The goal is to bridge individual T1s on a channelized DS3 onto a 
FastEthernet VLAN. So on one side we have a Juniper router which has a 
Fast-E connection to the 7206VXR. The 7206VXR terminates the DS3, and on 
the other side of the DS3 is a customer router. We want to use a /30 
subnet with one IP on the customer side and the other IP on the Juniper.

Here is the relevant configuration we've setup so far (which isn't 
working). If one of you can think of something else that would help solve 
the puzzle, let me know:

bridge crb

interface FastEthernet1/0.51
  encapsulation dot1Q 51
  no ip address
  no cdp enable
  bridge-group 51

interface Serial6/0/8:0
  description wardnet
  no ip address
  rate-limit input access-group 198 256000 8000 8000 conform-action 
transmit exceed-action drop
  no cdp enable
  bridge-group 51

bridge 51 protocol ieee
bridge 51 route ip

The problem, as I see it, is that the T1 isn't going to be providing ARP, 
which the Juniper will be expecting. Does anyone have experience with this 
kind of setup?

Thanks!
--Brad

--
Brad Ley -- Network Engineer

FRII

970-212-0755	bradl at frii.com
_______________________________________________
"Eat sushi frequently". - Avi
[email protected] is the human contact address.
[email protected] is the list posting address.
See below URL for subscribe/unsubscribe and list options:
http://inet-access.net/mailman/listinfo/list