Re: VOIP QOS setup Q

Whirlpool's database indicates the 502T does not support QoS:
http://whirlpool.net.au/index.cfm?a=h_view&model_id=228

This almost certainly means it won't add QoS markers, but I'm not sure
if it means it won't recognise them as well.

On Sun, Apr 6, 2008 at 12:36 PM, Voytek Eymont <[email protected]> wrote:
>
>  On Sun, April 6, 2008 8:35 am, Ben wrote:
>  > the problem you have is the upstream is only 128.
>  >
>  > even with QoS, a 1500 byte packet (MTU 1500) will take around 40ms to get
>  > through, which means any VoIP packet can suffer up to 40ms delay.
>  >
>  > Drop the MTU on your router (and probably everywhere else you can) to
>  > 576. this will result in slightly more traffic due to the higher
>  > overhead, but will reduce the delay.
>
>  thanks, Ben
>
>  it's a basic AAPT bundled Dlink 502T
>
>  MTU was 1400, I've now dropped it to 576
>  MRU is 1492
>
>
>
>
>  > XBox live will refuse to work with an MTU that low, I think everything
>  > else is fine though.
>
>  no Xbox, PS3 only
>
>  Voytek
>
>
>  > I'm not sure if the D-Link will be acknowledging QoS packets either. I
>  > have always found the best results for VoIP with Billion modems and
>  > routers.
>
>
>  --
>
>
> SLUG - Sydney Linux User Group Mailing List - http://slug.org.au/
>  Subscription info and FAQs: http://slug.org.au/faq/mailinglists.html
>
-- 
SLUG - Sydney Linux User Group Mailing List - http://slug.org.au/
Subscription info and FAQs: http://slug.org.au/faq/mailinglists.html