Re: SCSI on a blade 100 W/IDE

I am assuming you have done all of the basics like checking power, 
cables and termination.

You haven't stated any specifics concerning your "Store edge disk 
array", but is it possible that you HBA is single-ended, and your disk 
array requires either a HVD or LVD controller?

I have an Ultra20 M2 attached to a StoreEdge D1000 JBOD, and I needed a 
LVD controller, plus some other magic to make it all work.

Please post some specifics, i.e. what SCSI controller do you have?  And 
what StoreEdge array do you have, and any other specifics you might feel 
are relevant.

Hope this helps,

Jerry K




On 08/12/08 14:35, Howard Huntley wrote:
> I just purchased a Sun Blade 100 with a 80gig HD running Solaris
> v10.00. I want to connect my Sun scsi 12 disk "Store edge disk array"
> onto the sun Blade 100. The blade 100 arrived with a scsi card
> installed. I connected the drive pack to the scsi card and the system
> appears to accept the drive pack. When I go in to SMC to configure the
> array I can never find the scsi drive configurations on the blade
> system. I also attempted to put 2 tape drives on the end of the scsi
> chain then all seems to fail. Can anyone tell me how to resolve this
> delima??
> _______________________________________________
> Suns-at-Home mailing list
> [email protected]
> http://www.net-kitchen.com/mailman/listinfo/suns-at-home