Re: Connectors for battery

The one *on* the radio might be tough but read an old post below to the
BC296 I belong to. (the 250 and 296 are very similar radios) It looks like
most Uniden Cordless Phones use the same battery pack connector:

"I made several of them for fellow members. you can use some wire , be
sure you mash down the positive tip a bit or the batteries will be to
long. but dont mash them too much as they have a vent hole that lets
the heat escape when they are charging, also almost any uniden
cordless phonebatterys plug will work on the bc296. you mignt have to
trim a tiny bit of the edges of the plug . some have small wing like
edges on them. just put them side by side and you will be able to
figure it out. also radio shack is a great place to get used batteries
from as they are a drop off place for recycling old battery packs.
drop me a line if you need any help. Don"

-Roger

On Fri, Jan 9, 2009 at 9:27 PM, kurtn_ <[email protected]> wrote:

>   Where do you find the connector that is on the battery that attaches to
> the scanner? Also can you get the one in the scanner also?
>
> Kurt
>
>  
>


[Non-text portions of this message have been removed]