Re: Low battery problem!

Hi Kevin,

    I did check the battery with a volt meter and its putting 4.8VDC, the wall adapter is the Uniden one made for this scanner and is new so its not that plus it works great when I have the adapter plugged in to the 250D, I just get the low battery warning when I use the battery pack to power it.

John




--- In [email protected], "Kevin Higgins" <kevinhiggins47@...> wrote:
>
> John,
> Do you have a volt ohm meter?
> The battery voltage should be 4.8 vdc.  If not you probably have either a defective battery or something wrong with the charging circuit.
> 
> Also check the AC Adaptor, it is supposed to put out 12 vdc on the connector to the radio.
> 
> Kevin
> 
> 
>   ----- Original Message ----- 
>   From: j_g_sauchelli<mailto:j_g_sauchelli@...> 
>   To: [email protected]<mailto:[email protected]> 
>   Sent: Wednesday, July 08, 2009 7:09 PM
>   Subject: [UnidenBC250D] Low battery problem!
> 
> 
> 
> 
> 
>   I have a brand new battery pack that was charged fully in my 250D and still I get the low battery indicator and it beeps, is there a fix to this problem or do I have to send it back to Uniden for a repair?
> 
>   John
> 
> 
> 
>   
> 
> [Non-text portions of this message have been removed]
>