Re: "Reception 2"

Ok, it sounds like to me the Signal was VERY STRONG and the R-2 goes 
deaf on VERY STRONG signals unless the Attenuator is turned on. That 
may have been the only problem.

:-)

--- In [email protected], "blueray777" <bluestarborn@y...> wrote:
>   Most of the frequencies that were listed as active were in the 
> 123.ooo mhz up to 330.000 mhz. The web page I downloaded the info 
> from said to monitor these freq's in the AM band. But the little 
bit 
> of reception I got was in Wideband. I tried all the bands, only WFM
> worked. I scrolled through the squelch settings and open worked 
best, 
> but it sounded faint and with static. But sometimes a clear
> signal would come through with strength at 10 on the meter but it 
was 
> like I said before, muffled. You could see it come in over the 
other 
> transmission. If I set the squelch in Auto the faint signal would 
not 
> come in, but the other would be showing signal stregnth at 10. And 
> you could tell someone was talking because their wasnt any static, 
> just muffled. I dont know any other way to discribe it. 
> 
>                                                     Blueray



------------------------ Yahoo! Groups Sponsor ---------------------~-->
Get A Free Psychic Reading!
Your Online Answer To Life's Important Questions.
http://us.click.yahoo.com/aM1XQD/od7FAA/uetFAA/ELTolB/TM
---------------------------------------------------------------------~->

Post message:   [email protected] 
Subscribe:      [email protected] 
Unsubscribe:    [email protected] 
List owner:     [email protected] 
 

Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/